How to troubleshoot problems with self-propelled sprayers?

The emergence of self-propelled sprayer has helped mechanization of agricultural development, helping us to save manpower and material resources, and has been recognized by our customers. We only need to pay attention to the correct method when using it, we can guarantee that it will not appear when used. What's wrong, but after the machine has been used for a long time, there will be some faults that will affect our use. Then we should check it in time. As for how to do it, we will tell you in detail below.

What if the sprayer does not catch water? First of all, we analyze the reason: the switch is not in the correct position; the suction head filter is clogged; the suction pipe is seriously leaking; the lack of seal or seal is not placed. Remedy: Re-calibrate the handle position; remove the blockage; replace the suction pipe; reinstall or place the seal. Water absorption is slow. Cause: The valve of the pump inlet and outlet is worn; the valve spring of the pump inlet and outlet is broken; the suction pipe is leaking and blocked; the water level of the pool is too low, and the water absorption is difficult. Remedy: Replace the valve; replace the spring; check and remove; improve the water absorption conditions.

The pressure is not adjusted and the effluent is significantly reduced. Cause: The filter strainer is clogged; the V-belt is worn and the drive is slippery. Remedy: Remove the blockage; replace the V-belt.

The spray width and range are not enough. Cause: The fan speed is low; the fan V-belt wears and slips. Remedy: increase the throttle of the tractor, increase the engine speed, adjust the windshield of the fan exhaust vent; replace the V-belt.

Self-propelled sprayer problems How to properly check the method We have already told you in detail above, everyone should pay attention to the correct method when using, so that there will be no mistakes when using, hope us The way can help everyone.